Measure width and height in three places, note the frame depth, and use the smallest width and height. Always confirm sizes with the installer.
Accurate measurements prevent expensive ordering mistakes. The approach below is a general guide for a typical replacement window that fits inside the existing frame (often called an insert or pocket replacement). Methods differ for full-frame replacements and for some window types, so confirm the process with your supplier before ordering.
What you need
- A steel tape measure (not a cloth tape).
- A notepad or phone to record each window.
- A pencil and masking tape to label each window.
- A level, for checking whether the opening is out of square.
Step-by-step: measuring for an insert replacement
- Label each window with a location (for example "kitchen, left") and record the measurements under the same label.
- Remove obstructions such as blinds or trim covers that hide the frame.
- Measure the width at the top, middle and bottom of the opening, from one side of the frame to the other at the narrowest point inside the frame. Record all three and note the smallest.
- Measure the height on the left, middle and right, from the top of the frame to the sill. Record all three and note the smallest.
- Measure the depth of the frame to make sure the new window will fit. Compare it to the depth requirement stated for the product.
- Check the sill angle and level. Note any slope or visible bowing.
- Check squareness by measuring the two diagonals of the opening. A difference between them indicates the opening is out of square.
- Record anything unusual, such as rot, existing damage, obstructions, security bars or a nearby corner.
Why measure in three places?
Openings are rarely perfectly square. Taking three measurements shows how much the opening varies, and the smallest dimension is generally the one that determines whether a replacement unit fits. The installer then decides how much clearance to allow.
Do not subtract allowances yourself
Manufacturers and installers apply their own tolerances for the gap needed to fit and shim a window. Give them the raw measurements you recorded and let them determine the order size, unless they specifically tell you to subtract a set amount.
Full-frame replacement measurements
If the whole frame, including the trim and frame members, is being removed, measurements are taken of the rough opening, not the existing window. This usually requires removing interior or exterior trim and is generally best left to the installer or the supplier's measuring service.
Egress and building rules
If the window is in a bedroom or another room where it may serve as an emergency exit, the size of the clear opening may be regulated locally. Ask your local building authority or installer to confirm the requirements, instead of assuming a replacement keeps compliance.
Common measuring mistakes
- Measuring only once, at the middle of the opening.
- Measuring over trim or stops instead of the actual frame opening.
- Rounding measurements instead of recording fractions precisely.
- Forgetting to record the frame depth.
- Mixing up left and right, or inside and outside, when labelling.
Many suppliers and installers will measure for you, often as part of a quote. Even if you take your own measurements, ask them to verify, since they are responsible for the order. See common window installation mistakes and questions to ask before hiring a window installer.
Frequently asked questions
Should I measure from inside or outside?
For insert replacements it is common to measure from the inside, on the frame. Follow the supplier's instructions.
Which measurement should I use if the three differ?
Report all of them and highlight the smallest. The installer decides how to size the order.
Do I need to measure if the installer will do it?
It is optional, but having your own measurements helps you compare quotes and notice discrepancies.
Is the process different for bay or bow windows?
Yes. These are more complex and are usually measured by a professional.